#고정자

When a linear motor is in operation, the stationary part, which remains still, is called the stator. The primary function of the stator in a linear motor is to generate a magnetic field. It is composed of components such as the base, main magnetic pole, commutation pole, end cap, bearings, and brush device.

The core technology of BZD is on par with that of leading global manufacturers, such as K-Brand. This has been validated by European customers and successfully applied in relevant scenarios to effectively enhance cost reduction and operational efficiency for our clients.

1.Main Magnetic Pole:

The main function of the main magnetic pole is to generate the air gap magnetic field. It consists of a main magnetic pole core and an excitation winding. The core is typically made by stacking and riveting silicon steel plates with a thickness of 0.5mm to 1.5mm. It is divided into two parts: the pole body and the pole shoe. The part where the excitation winding is wound is called the pole body, while the widened part below is called the pole shoe. The pole shoe is wider than the pole body, allowing adjustment of the magnetic field distribution in the air gap and facilitating the fixation of the excitation winding. The excitation winding is made of insulated copper wire and wound around the main magnetic pole core. The entire main magnetic pole is fixed to the base with screws.

2.Commutation Pole:

The role of the commutation pole is to improve commutation and reduce sparking between the brushes and the commutator during motor operation. Typically installed between two adjacent main magnetic poles, it consists of a commutation pole core and a commutation pole winding. The commutation pole winding is made of insulated wire wound around the commutation pole core, and the number of commutation poles is equal to the number of main magnetic poles.

3.Base:

The outer casing of the motor stator is called the base. The base serves two purposes:

첫째로, it is used to fix the main magnetic poles, commutation poles, and end caps, providing support and fixation for the entire motor.

둘째, the base itself is also part of the magnetic circuit, serving as a magnetic path between the poles. The portion through which magnetic flux passes is called the magnetic yoke. To ensure that the base has sufficient mechanical strength and good magnetic permeability, it is generally made of cast steel or welded from steel plates.

4.Brush Device:

The brush device is used to introduce or extract DC voltage and current. It consists of brushes, brush holders, brush rods, and brush rod seats. The brushes are placed inside the brush holders and pressed by springs to ensure good sliding contact between the brushes and the commutator. The brush holders are fixed on the brush rods, which are mounted on a circular brush rod seat, and insulation is required between them. The brush rod seat is mounted on the end cap or bearing inner cover, and its circumferential position can be adjusted and fixed after adjustment.

우리의 모든 광섬유 케이블 패키지는 수출용 목재 드럼과 함께 제공됩니다.. 실내 FTTH 케이블의 목재 치수는 50x50x32cm입니다., 배송 길이 3km/드럼, 실외 광섬유 케이블의 목재 치수는 110cm*110cm*70cm입니다., 0.85CBM, 약 로드할 수 있습니다 33 20GP용 드럼. 고객의 맞춤형 케이블 드럼도 허용. 저희에게 연락을 환영합니다!

GYTS 직접 매장 단일 기갑 이중 칼집 광섬유 케이블

GYTS 광섬유 케이블 사진